Loading Supplies in Your DuraLabel Toro Max

Overview

To load your Toro Max with printing ribbon (“ink”) and label stock, you will need to fully raise the hinged cover.

How to Load Supplies

1. Lift the cover release latch and raise the cover of the printer; the ribbon rails will raise automatically. Make sure the cover and rails are fully raised before continuing.
2. Slide the ribbon cartridge into the slot in the rails. The cartridge will only fit the correct way, and a magnet will hold it in place. (To remove a ribbon cartridge, simply pull it out.)
3. Place the roll of label stock onto the supply spindle; for narrower supplies, hold the label stock roughly centered on the spindle by sliding a fixing tab onto the spindle from each side. Rest the supply in the supply well, with the spindle fitting into its slots. Fresh label stock should feed toward the cutter module, with the printable surface facing upward.
4. Slide the movable gray guides apart and feed the end of the label stock forward to reach over the platen roller. (You can flip the cutter module down for more room; simply pull the top edge away from the body of the printer.)
5. Slide the movable gray guides together so they hold the label stock neatly centered in the printer, without bending or wrinkling the label stock.
6. If you lowered the cutter module, lift it back into its ready position; it will snap into place. Finally, lower the cover until it latches closed; the ribbon rails will lower into place automatically.

Your Toro Max will recognize the supplies you have loaded and automatically adjust its print settings for the best quality. Now you’re ready to design and print custom labels!

More Support Options

If you have any questions about using your DuraLabel Toro Max printer, get help from Graphic Products’ world-class support team by calling 800-788-5572 or visiting GraphicProducts.com. We’re here to help with all your labeling needs!